Eurgle ESC-80A MANUAL 3page/14pages
Ⅵ Using the ESC
·Calibrate the throttle range of transmitter at the first time to use the controller (Recommend)
- Correctly connect the ESC with brushless motor, plug the receiver lead of ESC into receiver ( usually into
Channel 3);
- Put the throttle to the highest position, turn on the transmitter;
- Power on the receiver, ESC and motor. There are 3 beeps emitted from the motor, which indicates all elec-
tronics are correctly power on for the setting.
- Then there are 4 long beeps emitted from the motor ♪ ♪ ♪ ♪ .
- During or after the 4 long beeps , move the throttle to the lowest position, at this point, you have calibrated
the throttle range of your transmitter;
- Waiting one second, there will be two beeps emitted from the motor
- Calibration of throttle is completed.
·Program the ESC’ s settings or use the default setting (by Eurgle Program Card/ on PC/ by throttle
stick)
Recommend: Please always clearly know current parameters of ESC before use, and program it according to
your configuration. Please take the following form as reference to program the ESC ( Default setting is displayed
in blue. Throttle range in gray cannot be programmed but be auto changed after calibrating the throttle travel of
trans-
mitter.) Seeing the appendix about the detail programmable features of Eurgle ESC-80A.
♪
♪
NOTE: 1). If you have succeeded in calibrating the throttle range of transmitter, the throttle range will be dis-
played in ‘Programming Set’ window when you connect the controller to PC. The factory preset throttle
range is 640 uS.
LVC
Auto 5.0V 6.0V
(2 Lipo)
7.2V 8.4V 9.0V
(3 Lipo)
12.0V
(4 Lipo)
15.0V
(5 Lipo)
18.0V
(6 Lipo)
Current Limiting
Sensitivity Standard Insensitivity Disabled
Brake Type
No brake Soft brake Hard brake
Timing Advance
Auto Low Middle High
Cutoff Type
Hard cutoff Soft cutoff
Start Type
Soft start Standard Fast start
Governor Mode
Auto Governor Low Governor High
PWM Rate
8KHz 12KHz 16KHz
Throttle Range
640 uS
NOTE: 1) You also can program the ESC-80A through Eurgle Program Card. Please read the manuals of ‘Eurgle
Program Card’ for more detail instructions.
2) When program the settings by throttle stick of transmitter, please refer to the way described in the manu-
als of Eurgle ESC-75A-G-SE.
(18 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales