Eurgle ESC 100A HV MANUALS 3 page/ 14 pages
Ⅵ Using the ESC
·Calibrate the throttle range of transmitter at the first time to use the controller (Recommend)
- Correctly connect the ESC with brushless motor, plug the receiver lead of ESC into receiver ( usually into
Channel 3);
- Put the throttle to the highest position, turn on the transmitter;
- Power on the receiver, ESC and motor. There are 3 beeps emitted from the motor, which indicates all elec-
tronics are correctly power on for the setting.
- Then there are 4 long beeps emitted from the motor ♪ ♪ ♪ ♪ .
- During or after the 4 long beeps , move the throttle to the lowest position, at this point, you have calibrated
the throttle range of your transmitter;
- Waiting one second, there will be two beeps emitted from the motor
- Calibration of throttle is completed.
·Program the ESC’ s settings or use the default setting (by Eurgle USB/ on PC/ by throttle stick)
Recommend: Please always clearly know current parameters of ESC before use, and program it according to
your configuration. Please take the following form as reference to program the ESC ( Default setting is displayed
in blue. Throttle range in gray cannot be programmed but be auto changed after calibrating the throttle travel of
transmitter.) Seeing the appendix about the detail programmable features of Eurgle ESC 100A HV.
♪
♪
NOTE: 1). Eurgle ESC 100A HV has no built-in BEC, so a separate receiver pack or UBEC is needed to
supply power for receiver and servos.
2). If you have succeeded in calibrating the throttle range of transmitter, the throttle range will be
displayed in ‘Programming Set’ window when you connect the controller to PC. The factory
preset throttle range is 640 uS.
LVC
Auto 5.0V 6.0V
(2 Lipo)
7.2V 8.4V 9.0V
(3 Lipo)
12.0V
(4 Lipo)
15.0V
(5 Lipo)
18.0V
(6 Lipo)
21.0V
(7 Lipo)
24.0V
(8 Lipo)
27.0V
(9 Lipo)
30.0V
(10 Lipo)
33.0V
(11 Lipo)
36.0V
(12 Lipo)
Current Lim-
iting
Sensitivity Standard Insensitivity Disabled
Brake Type
No brake Soft brake Hard brake
Timing Ad-
vance
Auto Low Middle High
Cutoff Type
Hard cutoff Soft cutoff
Startup Type
Soft start Standard Fast start
G o v e r n o r
Mode
Auto
Governor
Low
Governor
High
PWM Rate
Low Middle High
T h r o t t l e
Range
640 uS
NOTE: 1) You also can program the ESC 100A HV through Eurgle USB, but a separate receiver pack or UBEC
(voltage must be or less than 6V) is needed to connect to ‘Reserve for OPTO’. Please read the manuals
of ‘Eurgle ESC USB Linker’ for more detail instructions.
(14 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales