R2hobbies.com Eurgle Especificaciones descargar pdf (Pagina 13)

· Timing Advance

· Cutoff Type

NOTE: Soft cutoff is always automatically active in Governor Mode.

· Soft Start

· Governor Mode

NOTE: The Governor mode acts as an RPM control. Throttle stick position determines the RPM that the motor

runs and the controller will attempt to hold that RPM regardless of load changes. In Governor Mode, the brake is

always disabled and soft cutoff is automatically active.

Option 1: Low advance timing Recommended for more lower pole count motors. Gives more power and

slightly less efficient.

Option 2: middle advance timing Recommended for most motors .Gives a good balance of power and efficiency.

Option 3: High advance timing Recommended for most of higher pole count motors

Option4:Auto(default) Recommended for most of all brushless motors.

Option 1 :Hard cutoff (default)

When battery voltage reaches cut-off voltage the motor will shutdown immedi-

ately. Motor can be restarted by closing the throttle to the lowest position and

then move the throttle as normal

Option 2: Soft cutoff

When battery voltage reaches cut-off voltage, the ESC will slowly reduce motor

power to zero, you will notice a decrease in power and it is time to land, the throt-

tle maintains its full linear response.

Option 1: Soft start

Recommended for helicopters

Option 2:Standard start (default)

Recommended for most of the fixed or folding prop airplanes, and some heli-

copters.

Option 3: Fast start

Recommended for fastest startup.

Option 1: Auto calibrating throttle

(default)

Recommended for general aircraft

Option 2: Governor Low

For helicopter application. Throttle’s response is slower, and control gain is lower.

Option 3: Governor High

For helicopter application. Throttle’s response is quicker, and control gain is

higher

1 2 ... 8 9 10 11 12 13 14

Sin comentarios

R2hobbies.com Eurgle Especificaciones Pagina 13